|
|
|
|
|
||
"Copy"
this photo and "paste" it into your photo editing program and
enlarge it to 5.93" Wide by 7.35" Tall. When you're
finished printing them, overlap the two "back" halves until you get a template that will give you the
front of the
wheelbarrow measuring 7 1/8" tall, 11 1/2" wide at the top and 9 1/2"
wide at the bottom. Then tape them together.
|
|
|
|
"Copy"
this photo and "paste" it into your photo editing program and
enlarge it to 8.51" Wide by 11.95" Tall.
|
|
|
|
"Copy"
this photo and "paste" it into your photo editing program and
enlarge it to 8.51" Wide by 11.95" Tall. When you're
finished printing them, overlap the two "front" halves until you get a template that will give you the
front of the
wheelbarrow measuring 9" tall, 12" wide at the top and 9 1/2"
wide at the bottom. Then tape them together.
|
|
|
|
"Copy"
this photo and "paste" it into your photo editing program and
enlarge it to 8.50" Wide by 10.96" Tall.
|
|
|
|
|
|
|
"Copy"
this photo and "paste" it into your photo editing program and
enlarge it to 8.50" Wide by 10.96" Tall. After you print
out all three "side" photos, tape them together overlapping as needed until you get a
shape that is 14 3/4" across the bottom, 9" tall at the highest
point, and 17" wide measuring across the top from each pointed
corner. Which means your tape is on a slight angle for this last
measurement.
|
|
|
|
"Copy"
this photo and "paste" it into your photo editing program and
enlarge it to 7.32" Wide by 1.5" Tall. When you're
finished you should have a template that will give you the end of the
handle. Lay it on your 1 X 2 and adjust as needed.
|
|
